The electric hydraulic ARK-150-WNP offers the quickest and easiest methodology for installing the patch fasteners. Lacer includes both a heating/pressing station and a cooling station.

The AHP-120-WNP offers a manual, yet quick, method for installing the patch fasteners. Lacer includes both a heating/pressing station and a cooling station.

Gone are the days where binding laundry tapes and installing wire hooks were two different processes. With the Anker® Laundry Patch Fastener System binding of the cotton laundry tapes and fastener installation is a single installation process. Anker Wire Hooks are supplied preloaded into a patch material.
The lacer applies pressure to the heated jaws to properly clinch the fasteners while simultaneously heating and activating the glue on the inside of the patch. The glue becomes liquid and permeates the laundry tape, and when cooled, binds the laundry tape fibers to prevent the fasteners from pulling through the belt end.

Customer Value:

• One step process means no messy binder process and no fumes to inhale
•  Fast installation and long-lasting splices ensure no lost production time
• Patch covering prevent hooks from catching and damaging linens
• From hours to seconds – the entire Anker® patch process takes only 20 seconds

Transferring products safely throughout your operation is paramount to maximizing production efficiency. Transition points, whether from one conveyor to another, from the belt to a chute, or from a belt to a structure, represent a large challenge in many industries, including Parcel Logistics, Baggage Handling, Food & Beverage, and others. Segmented Transfer Plates (STP) from Flexco can help prevent product loss, increase operator safety, and reduce pinch hazards at the transfer point, preventing potential damage to the product as well as the belt and conveyor structure. Bright yellow segments snap onto the mounting bar to accommodate belts up to 1500mm (60") wide and gaps from 100 to 250mm (4 to 10"). A Segmented Transfer Plate design with a narrower support bar is also available for smaller pulley to pulley gaps from 38 to 75mm (1.5 to 3").